3D model
Turn it over
A procedural model built in Blender from published dimensions, drawings and photographs, painted as the Fa 223 V14, Werknummer 22300014 (DM+SR in Luftwaffe service), as photographed in RAF markings at the Airborne Forces Experimental Establishment, Beaulieu, in September–October 1945, after its German crew and Allied observers flew it across the Channel to Brize Norton on 6 September, the first helicopter to make the crossing (no Fa 223 survives): a steel-tube, fabric-covered fuselage with a glazed nose and a BMW 323 radial amidships, two 12 m three-blade rotors carried on braced outrigger trusses to give a 24.5 m span over the blade tips, a T-tail on a single fin, and a fixed tricycle undercarriage with twin nose wheels, shown standing level with the blades parked and drooping; shape from a published three-view drawing scaled to the 12.2 m fuselage and 12.5 m rotor spacing, with markings taken from the Beaulieu photographs: a uniform dark finish, rendered here as dark green because every photograph is black and white, light grey outrigger tubes, Type C1 roundels on the rear fuselage and a Type C fin flash, with no serial or code because none shows; the lighter truss bracing and the nose glazing frames are simplified. Drag to orbit, scroll or pinch to zoom · download .glb (909 KB)
Data plate
Specification
- First flight3 August 1940
- Built~20
- Top speed~110 mph
- Engine1 × BMW-Bramo 323 Q3 Fafnir nine-cylinder radial, about 1,000 hp, driving both rotors through shafts in the outriggers
- Crew2
- Wingspan24.5 m
- Length12.25 m
- Height4.35 m
- In service1942–1945 (Luftwaffe)
- RoleTwin-rotor transport helicopter
- MakerFocke-Achgelis, Delmenhorst (later Laupheim), Germany
- UK collections—
First flight, number built and top speed are for the whole family (Fa 223 Drache); engine, crew and dimensions are for the Fa 223E Drache, V14 modelled here.
History
The Fa 223
Heinrich Focke had shown with the little Fa 61 of 1936 that a helicopter with two side-by-side rotors could fly properly, and in 1938 Lufthansa ordered a much bigger one for passengers, the six-seat Fa 266 Hornisse. The war came before it flew, and the design was taken over by the Luftwaffe as the Fa 223 Drache, or Kite. A single Bramo radial sat in the middle of a steel-tube fuselage, driving two three-blade rotors of 12 metres carried at the ends of braced outriggers, one each side.
The first prototype flew in August 1940, and that autumn it set unofficial records for speed, climb and height, reaching over 7,000 metres. The Luftwaffe planned large numbers for transport, rescue and reconnaissance, but Allied bombing kept destroying the factories: the Delmenhorst works were hit in 1942 and production moved to Laupheim, then again to Berlin. Only about twenty were completed. The few that served with Lufttransportstaffel 40 lifted guns, stores and wrecked aircraft in slung loads, and were tried out for rescue work in the Alps.
At the end of the war the Americans captured several, and one, V14, was flown across the English Channel by its German crew with Allied observers on 6 September 1945, the first helicopter to make the crossing. It was tested at the Airborne Forces Experimental Establishment at Beaulieu until a drive-shaft failure wrecked it a month later. France and Czechoslovakia each assembled a few more from German parts after the war, but no Fa 223 survives, and none is in a UK museum.
This airframe
Fa 223E V14, Werknummer 22300014
No Fa 223 survives and none is held by a UK museum, so the model follows V14, Werknummer 22300014, coded DM+SR in Luftwaffe service, as photographed in RAF markings at Beaulieu in September and October 1945 after its Channel crossing; about six photographs of it there make it the best-recorded single airframe of the type. It is shown in a uniform dark finish with light grey outrigger tubes, Type C1 roundels on the rear fuselage and a Type C fin flash, with no serial or code because none shows in the photographs. The photographs are black and white, so the dark green is inferred. The shape comes from a published three-view drawing scaled to the 12.2 m fuselage and the 12.5 m spacing of the rotors, and the twin nose wheels and dark lower nose follow the photographs. The blades are parked as in the photographs, one of each rotor pointing straight outboard. The lighter bracing in the outriggers and the frames of the nose glazing are simplified.
Where to see one
Not on charge
No complete example survives.