3D model
Turn it over
A procedural model built in Blender from published dimensions, drawings and photographs, painted as Vought F7U-3M Cutlass BuNo 129655, displayed at the National Naval Aviation Museum, Pensacola, Florida (no Cutlass is in a UK museum): the US Navy's tailless twin-engined carrier fighter, with a swept wing carrying twin fins, two afterburning Westinghouse J46 engines and a very long nose undercarriage leg that sits it steeply nose-high, shown in light gull grey over white with a black radome, red intake lips and danger markings, the star-and-bar on the nose and wings, and NAVY under the port wing; the wings are shown spread and the slats closed.. Drag to orbit, scroll or pinch to zoom · download .glb (1.2 MB)
Data plate
Specification
- First flight29 September 1948
- Built320
- Top speed~680 mph
- EngineTwo Westinghouse J46-WE-8 afterburning turbojets, 6,000 lbf (26.7 kN) each with afterburner
- Crew1
- Wingspan12.09 m
- Length13.13 m
- Height4.36 m
- In service1954 to 1957 with US Navy fleet squadrons, then shore units until 1959
- RoleSingle-seat carrier-based fighter
- MakerChance Vought Aircraft, Dallas, Texas, United States
- UK collections—
First flight, number built and top speed are for the whole family (F7U-3); engine, crew and dimensions are for the F7U-3M 129655 modelled here.
History
The F7U-3M
The Cutlass was Vought’s answer to a 1945 US Navy call for a carrier day fighter able to reach 600 mph at 40,000 ft. The designers, who had German wartime research on swept wings to hand, did away with the tailplane altogether: a broad swept wing carried a fin and rudder on each side, and its trailing-edge surfaces, which Vought called ailevators, worked as both elevators and ailerons. Full-span leading-edge slats and a very long nose undercarriage leg gave the steep angle needed for carrier landings. The first XF7U-1 flew on 29 September 1948. Only 14 production F7U-1s followed; their Westinghouse J34 engines were too weak, and all three prototypes were lost.
The F7U-3 was close to a new aeroplane, larger and stronger, with a deeper fuselage, a raised cockpit for a better view on the approach and four 20 mm cannon above the intakes. It first flew on 20 December 1951, at first with Allison J35s because its intended Westinghouse J46 engines were late, and when they came they gave less thrust than promised. Squadrons began to receive it in 1954. The F7U-3M carried four Sparrow I radar-guided missiles under the wings, and the F7U-3P was an unarmed photographic version, of which 12 were built. In all about 320 Cutlasses of every version were made.
In service the Cutlass was fast, strong and agile, but short of power, hard to see out of on the approach and prone to failures of its engines, hydraulics and nose leg. Pilots called it the Gutless Cutlass, and more than a quarter of those built were lost in accidents. Thirteen Navy squadrons flew it, some only briefly and several ashore after their carrier captains had the type put off the ship. The fleet gave it up in 1957 for the Vought F8U Crusader and other new fighters, and the last had gone from shore units by 1959. A handful survive in the United States.
This airframe
F7U-3M 129655 at the National Naval Aviation Museum, Pensacola
No Cutlass is in a UK museum, so the model follows the best-photographed survivor: F7U-3M Bureau Number 129655, at the National Naval Aviation Museum at Pensacola, Florida. It is light gull grey above and white below, with white control surfaces, a black radome, red intake lips with red danger outlines, bare-metal slats, black walkways at the wing roots, the star and bar on the nose and wings, NAVY under the port wing and the type and serial in small letters on the nose. The museum shows it with its wings folded, its slats drooped and drop tanks that it did not carry in service; the model has the wings spread, the slats closed and no tanks. It sits at the steep nose-high angle of the real aircraft, about ten degrees. The shape follows a three-view drawing checked against a second, corrected Vought drawing and photographs of this airframe. The undercarriage doors and linkages are reconstructed from a few photographs, the arrester hook, cannon ports and small stencils are left off, surfaces no photograph shows are left plain and the cockpit interior is generic.
Where to see one
Not on charge
A handful survive in US museums. None is in a UK museum.